Home
Hello, I am new to CTW ownership and the forum. I didn't look to see if there is an introduction section, so here is my intro... I live in the USA, in the state of Florida. I have been playing airsoft for about 4 years. I have worked on quite a few aeg's and spring snipers. I don't claim to be the best airsmith, but a lot of what I have tried has worked out.
I recently purchased a CTW M4A1 MX2, second hand. I have barely used it, it came with its silver cylinder. I ordered the upgrade cylinder from Evike and put it in tonight. While I was testing it out, the gun went into full auto and would not stop firing. I was actually in semi when it happened. It will stop only when I switch it to safe. It seems to me like the selector switch is making some funny noise when I turn it. I had an 11.1 20C lipo attached when this happened.
Any ideas or suggestions on where to start, would be greatly appreciated.
-Thanks
I recently purchased a CTW M4A1 MX2, second hand. I have barely used it, it came with its silver cylinder. I ordered the upgrade cylinder from Evike and put it in tonight. While I was testing it out, the gun went into full auto and would not stop firing. I was actually in semi when it happened. It will stop only when I switch it to safe. It seems to me like the selector switch is making some funny noise when I turn it. I had an 11.1 20C lipo attached when this happened.
Any ideas or suggestions on where to start, would be greatly appreciated.
-Thanks